Operation Manual

31
Menu Operations
2. LNB Power: If your receiver is
connected to the LNB directly then you
need to set the LNB Power to “On”. If
your receiver is connected to a multi
switch (SMATV signal distribution
system) then it may be that you don’t
need to provide the power to the LNB.
But since this is depending on the kind
of installed distribution system we
recommend you to contact your installer or to refer to the user manual of
this system to get the correct information.
You also just can change this setting and check if you still can receive the
channels. If the LNB Power is off and you still can see all channels then we
recommend this setting.
3. Low Power Consumption: At this option, you could Enable / Disable the low
power consumption mode. This mode allows saving current consumption
when the receiver is stand-by.
Low power consumption mode only can be enabled when the VCR
Loopthrought option (see point 5.2.) is STB master selected. By the other
way, if you choose VCR master, then the Low Power Consumption option
will not be active and the receiver will not be in LPC mode.
4. Press [Exit] button to leave this menu.
5. Press [Exit] button to leave this menu.