Operation Manual

WARNING: Use the apparatus only in moderate climates (not in tropical

climates).

Note: Do not open the cabinet to avoid the unit direct exposure to radiation.

Unit Cleaning:

fter the unit power is turned off, you can clean the cabinet,

panel and remote control with a soft cloth lightly moistened with a mild detergent

solution.

Attachments: Never add any attachments and/or equipment without the

manufacturer consent; as such additions may result in the risk of fire, electric

shock or other personal injury.

Locating: Slots and openings in the cabinet are provided for ventilation to

protect it from overheating. Do not block these openings or allow them to be

blocked by placing the STB on a bed, sofa or other similar surface, nor should it

be placed over a radiator or heat register.

Power-Cord Protection: Place the power-supply cord out of the way, where it

will not be walked on. Please take special attentions to cords at plugs,

convenience receptacles and the point where they exit from the unit.

Object and Liquid Entry: Never put objects of any kind into this STB through

openings, as they may touch dangerous voltage points or short-out parts that

could result in a fire or electric shock. Never spill any liquid on the STB.

Note: Moisture may be formed inside the unit in the following conditions:

When the unit is suddenly moved from a cold environment or an air-condition

room to a warm place.

Immediately after a heater has been turned on.

In a steamy or very humid room.

If the moisture forms inside the unit, it may not operate properly. To correct this

problem, turn on the power and wait about two hours for the moisture to

evaporate.

Parts Replacement: When the unit parts need to be replaced, user should

make sure the service technician use the replacement parts specified by the

manufacturer or having the same characteristics as the original part.

Unauthorized replacement may put the unit in the risk of fire, electric shock or

other hazards.

Safety Check: After all the maintenances and repairs are done, user is required

to request the service technician to conduct the overall safety check to ensure

the machine is in the proper condition.