Installation guide

© MuxLab Inc. 6G-SDI Extender Over UTP
Page 8
Connectivity - Transmitter
Front Side
4x BNC Connectors for SDI Input (0.8V pp, 75Ohms)
1x BNC Connector for Sync Output
Rear Side
1x RJ-45 Ethercon Connector (Compatible with NE8MC
System)
Top Side
Mini USB for firmware updates (and control & status)
Table 2 – Connectivity Transmitter
Connectivity - Receiver
Front Side
Mini USB for firmware updates (and control & status)
Rear Side
1x RJ-45/UTP Connector
4x BNC Connectors for SDI Output (0.8V pp, 75Ohms)
1x BNC Connector for Sync Input
1x Power Connector (5.5mm x 2.1mm)
Table 3 – Connectivity Receiver