User Manual

English

2. To install the bracket unscrew the

base from the bracket, mark the holes

on the wall using the base, use the plugs

and screws supplied with the product to

anchor it to the wall.

3. Screw the bracket onto the base that

you have installed on the wall. Install the

camera sleeve as follows:

INSTALL YOUR CAMERA

1. Slide the switch to the open position “Lock open” and

open the cover, then if you want to install a memory card

(MicroSD not included), make sure it is formatted in FAT

32 and is not Ultra or the LED will ﬂash red continuously

and you will not be able to reset the camera. Once the

card is installed, insert the battery taking into account

the polarity (positive and negative) indicated in the

battery compartment.

Insert the camera

into the ﬂexible

sleeve and thread

the cable through

the hole in the

sleeve on the

bottom of the

camera where

the micro USB

charging connector

is located.