User`s guide

Rockhopper 38 – User’s Guide
Page 96 AP-75038, Rev. 1.0. – 27/05/04
Step 6:
If no other items are to be changed, press the [BACK½] key.
Step 7:
Do not press any other keys for 3 minutes or press [BACK½] key again.
Step 8:
The permanent display is restored.
5.4.6.2. Initialize
1. All
Restores the contents of all backed up settings to the values set when shipped by Mutoh.
Yes:
All backed up settings are restored to the factory settings
No:
Factory settings are not restored
To change the Initialize All setup proceed as follows:
Step 1:
If a menu is to be specified, press the [MENU] key.
Step 2:
The key contents change to the purple section on the outside of the
operation panel.
Bring up the "Utility" menu by pressing the [MENU UP¿] key or [MENU
DOWNÀ] key.
Step 3:
Press the [ENTER] key to confirm the "Utility" menu and shift to the next
level.
Step 4:
Bring up the "Initial" item by pressing the [MENU UP¿] key or [MENU
DOWNÀ] key.
Step 5:
Press the [VALUE+] key or [VALUE-] key to specify "No" or "Yes".
Step 6:
Press the [ENTER] key to confirm "Initial" and shift to "Initial All".
Step 7:
Bring up the "Initial All" item by pressing the [MENU UP¿] key or [MENU
DOWNÀ] key.
Step 8:
Press the [VALUE+] key or [VALUE-] key to specify "No" or "Yes".
Plot OK
Plot OK
Initial: No
*Menu* Utility >
*Menu* Command >
*Menu* Utility >
Error Display Off
Initial: No
Initial: Yes >
Initial All: No
Initial All: OK