User`s guide

Rockhopper 38 – User’s Guide
Page 95 AP-75038, Rev. 1.0. – 27/05/04
5.4.6. Utility Setup
*Menu* Utility >
Error display
On / Off
Initialize
OK / No
All
OK / No
Command
OK / No
Function
OK / No
RS-232C
OK / No
Centronics
OK / No
Network
OK / No
Data dump
Start-End / All (cancel with Cancel-key)
Head wash
Black & Colour / Black / Colour
Factory default setting item is marked in Bold
Utility Setup
Set-up for errors and initialization.
5.4.6.1. Error Display
Specifies whether the error LED will light and error details will be displayed in the liquid crystal display unit
when a minor error has occurred.
On:
The error LED will light and error details will be displayed in the liquid crystal display unit
when a minor error has occurred
Off:
No indication will be given of a minor error occurring, either by error LED or by the liquid
crystal display unit
To change the Error Display setup proceed as follows:
Step 1:
If a menu is to be specified, press the [MENU] key.
Step 2:
The key contents change to the purple section on the outside of the
operation panel.
Bring up the "Utility" menu by pressing the [MENU UP¿] key or [MENU
DOWNÀ] key.
Step 3:
Press the [ENTER] key to confirm the "Utility" menu and shift to the next
level.
Step 4:
Press the [VALUE+] key or [VALUE-] key to switch to "Off" or "On".
Step 5:
Press the [ENTER] key to confirm "Error display" and shift to "Initial".
Plot OK
*Menu* Utility >
*Menu* Utility >
Error Display: Off
Error Display: On