User`s guide

Rockhopper 38 – User’s Guide

Page 93 AP-75038, Rev. 1.0. – 27/05/04

5.4.5. Network Setup

*Menu* Network >

IP Address 000.000.000.000 to 192.034.043.015 to 255.255.255.255

Factory default setting item is marked in Bold

Network Setup

Set-up for the network connection (Ethernet).

5.13.5.1. IP Address

Sets up IP address for the network connection (Ethernet).

Enter the IP address assigned by your network administrator

After making the setting, turn the printer off momentarily and restart it.

¾ to 192.034.043.015 to 255.255.255.255

To change the IP Address mode setup proceed as follows:

Step 1:

If a menu is to be specified, press the [MENU] key.

Step 2:

The key contents change to the purple section on the outside of the

operation panel.

Bring up the "Network" menu by pressing the [MENU UP¿] key or [MENU

DOWNÀ] key.

Step 3:

Press the [ENTER] key to confirm the "Network" menu and shift to the next

level.

Step 4:

Press the [VALUE+] key or [VALUE-] key to set the first part of the IP

address to a number between "001" and "255". (The first part identifies the

country and 192 is usually used in a LAN environment.

Step 5:

Press the [ENTER] key to confirm the first address and shift to the second

address.

Step 6:

Press the [VALUE+] key or [VALUE-] key to set the second part of the IP

address to a number between "001" and "255".

Step 7:

Press the [ENTER] key to confirm the second address and shift to the third

address.

Plot OK

*Menu* Network>

-> 192.034.041.015

192 -> 034.041.015