User`s guide

Rockhopper 38 – User’s Guide

Page 91 AP-75038, Rev. 1.0. – 27/05/04

5.4.4. Centronics Setup

*Menu* Centronics >

Mode Centronics / Bitronics

Timing A-B / B-A

Factory default setting item is marked in Bold

Centronics Setup

Making online settings for the Centronics connection.

5.5.4.1. Mode

Sets the mode for the Centronics connection.

Centronics:

Selects fixed uni-directional Centronics communication

Bi Centro:

Selects Bi Centronics that allows two-way communication (supports compatible

mode, nibble mode, ECP mode)

To change the Centronics mode

setup proceed as follows:

Step 1:

If a menu is to be specified, press the [MENU] key.

Step 2:

The key contents change to the purple section on the outside of the

operation panel.

Bring up the "Centro" menu by pressing the [MENU UP¿] key or [MENU

DOWNÀ] key.

Step 3:

Press the [ENTER] key to confirm the "Centro" menu and shift to the next

level.

Step 4:

Press the [VALUE+] key or [VALUE-] key to switch to "Centro" or "Bi

Centro".

Step 5:

Press the [ENTER] key to confirm "Mode" and shift to "Timing".

Step 6:

If no other items are to be changed, press the [BACK½] key.

Step 7:

Do not press any other keys for 3 minutes or press [BACK½] key again.

Step 8:

The permanent display is restored.

Plot OK

*Menu* Centro >

Mode: Centro

Mode: Bi Centro

Timing: A-B

*Menu* Centro >