User`s guide

Rockhopper 38 – User’s Guide
Page 89 AP-75038, Rev. 1.0. – 27/05/04
To change the RS-232C setup proceed as follows:
Step 1:
Press [MENU] to set up the menu.
Step 2:
Press [MENU UP¿] key or [MENU DOWNÀ] key to display
RS-232C menu.
Step 3:
Press [ENTER] key to confirm the “RS-232C” menu and shift to the next
level.
Step 4:
Press [VALUE+] key or [VALUE-] key to select displayed Baudrate to
4800bps, 9600bps, 19200bps and 38400bps.
Step 5:
Press [ENTER] to confirm BaudRate item, and shift to Data.
Step 6:
Press [VALUE+] key or [VALUE-] key to change the displayed Data length
to 7bits or 8bits.
Step 7:
Press [ENTER] key to confirm Data item, and shift to Parity.
Step 8:
Press [VALUE+] OR [VALUE-] to change displayed Parity to None, Even
and Odd.
Step 9:
Press [ENTER] to confirm Parity, and shift to Stop Bit.
Step 10:
Press [VALUE+] key or [VALUE-] key to change displayed StopBit to 1bit or
2bits.
Step 11:
Press [ENTER] key to confirm StopBit, and shift to Protocol.
Step 12:
Press [VALUE+] key or [VALUE-] key to change displayed Protocol to
None, X on, and Hard.
Step 13:
Press [ENTER] key to confirm Protocol and shift to CTS Cont.
Step 14:
Press [VALUE+] key or [VALUE-] to select CTS Control to Off or On.
Step 15:
Press [ENTER] to confirm CTS Control item, and shift to BaudRate.
CTS Cont.: On
*Menu* Command>
BaudRate: 9600bps
BaudRate: 19200bps
Data: 8 Bits
Data: 7 Bits
Parity: None
Parity: Even
Stop Bit: 1 Bit
Stop Bit: 2 Bits
Protocol: None
Protocol: X on
CTS Cont.: Off
Plot OK
*Menu* RS-232C>