User`s guide

Rockhopper 38 – User’s Guide
Page 86 AP-75038, Rev. 1.0. – 27/05/04
5.4.2.11. Distance Adjustment
Based on an actual print, enter the measured X-axial distance and the data length. If there is no previous
setting, the length and width of the last plot will be displayed. Since distance compensation is intended to
align the user’s scale, it does not ensure the accuracy of the distance.
No:
No distance compensation is performed
Clear:
The previous distance compensation value is erased
Change:
A new distance compensation value is established
Confirm:
The distance compensation value is verified
To change the Distance Adjustment setup proceed as follows:
Step 1:
Select "Function Setting" with the [MENU] key and press [ENTER] key to
confirm the selection
Step 2:
Press [MENU UP¿] key or [MENU DOWNÀ] key to select "Distance
Adjustment" and press [VALUE+] key or [VALUE-] key to bring up to
"Change"
Step 3:
Press [ENTER] key to confirm the "Distance Adjustment" menu and shift to
the next level.
Step 4:
Press [MENU UP¿] key or [MENU DOWNÀ] key to shift to the "Distance
Adjustment X-axial data" digit that is to be altered.
The number that is displayed is the current setting. If there is no previous
setting, the number will be the width of the last print. The digit to be altered
is underlined.
Step 5:
Press [VALUE+] key or [VALUE-] key to change the value of the digit.
Step 6:
Press [MENU UP¿] key or [MENU DOWNÀ] key to shift to another digit
that is to be altered.
Step 7:
Press [VALUE+] key or [VALUE-] key to change the value of the digit.
Step 8:
Press [ENTER] key to confirm the "Distance Adjustment X-axial data value"
Step 9:
Since the "Distance Adjustment X-axial data value" is displayed, this will be
set to the measured X distance that was actually plotted.
Press [MENU UP¿] key or [MENU DOWNÀ] key to shift to the "X-axial
data" digit that is to be altered.
*Menu* Function>
Distadj: No
Distadj: Change
Data X: 00841.00
Data X: 00841.00
Data X: 00801.00
Data X: 00801.00
Data X: 00800.00
Real X: 01000.00