User`s guide

Rockhopper 38 – User’s Guide

Page 85 AP-75038, Rev. 1.0. – 27/05/04

5.4.2.10 Ink Density

Normal:

printing with normal intensity

Faint:

printing with an intensity lighter than Normal

Thin:

printing with an intensity lighter than Light

All three intensities are effective at 720 dpi but at 360 dpi, the printing intensity will be Normal even when

Light or Faint are selected.

To change the Ink Density setup proceed as follows:

Step 1:

If a menu is to be specified, press the [MENU] key.

Step 2:

The key contents change to the purple section on the outside of the

operation panel.

Bring up the "Function" menu by pressing the [MENU UP¿] key or [MENU

DOWNÀ] key.

Step 3:

Press the [ENTER] key to confirm the "Function" menu and shift to the next

level.

Step 4:

Bring up to the "Ink Density" item by pressing the [MENU UP¿] key or

[MENU DOWNÀ] key.

Step 5:

Press the [VALUE+] key or [VALUE-] key to specify "Normal”, “Faint" or

"Thin".

Step 6:

Press the [ENTER] Key to confirm "Ink Density"

and shift to "Distance Adjustment".

Step 7:

If no other items are to be changed, press the [BACK½] key.

Step 8:

Do not press any other keys for 3 minutes or press [BACK½] key again.

Step 9:

The permanent display is restored.

Plot OK

*Menu* Command>

*Menu* Function>

Ink Density: Normal

Ink Density: Faint

Ink Density: Thin

Distance Compensation: