User`s guide

Rockhopper 38 – User’s Guide

Page 84 AP-75038, Rev. 1.0. – 27/05/04

5.4.2.9. Copy

Specifies the number of copies when the data is to be printed several times.

1 to 99

To change the Copy setup proceed as follows:

Step 1:

If a menu is to be specified, press the [MENU] key.

Step 2:

The key contents change to the purple section on the outside of the

operation panel.

Bring up the "Function" menu by pressing the [MENU UP¿] key or [MENU

DOWNÀ] key.

Step 3:

Press the [ENTER] Key to confirm the "Function" menu and shift to the

next level.

Step 4:

Bring up the "Copy" item by pressing the [MENU UP¿] key or [MENU

DOWNÀ] key.

Step 5:

Press the [VALUE+] key or [VALUE-] key to set the number of copies

between "1" and "99".

Step 6:

Press the [ENTER] key to confirm the number of copies of the applicable

print and shift to "Ink Density".

Step 7:

If no other items are to be changed, press the [BACK½] key.

Step 8:

Do not press any other keys for 3 minutes or press [BACK½] key again.

Step 9:

The permanent display is restored.

Plot OK

*Menu* Command>

*Menu* Function>

Copy: 1

Copy: 15

Ink Density: Normal