User`s guide

Rockhopper 38 – User’s Guide

Page 83 AP-75038, Rev. 1.0. – 27/05/04

5.4.2.8. Media Cut

Selects whether roll media will be cut or not at the end of printing. If off is selected, the data can be printed

again on the same page.

Off:

Auto-cut:

Roll media is cut automatically when printing ends.

Manual cut:

In this case the user has to cut off manually the roll of media when printing ends.

Use this for cutting media that cannot be cut automatically (fireproof cloth or

outdoors cloth).

To change the Media Cut setup proceed as follows:

Step 1:

If a menu is to be specified, press the [MENU] key.

Step 2:

The key contents change to the purple section on the outside of the

operation panel.

Bring up the "Function" menu by pressing the [MENU UP¿] key or [MENU

DOWNÀ] key.

Step 3:

Press the [ENTER] key to confirm the "Function" menu and shift to the next

level.

Step 4:

Bring up the "Media Cut" item by pressing the [MENU UP¿] key or [MENU

DOWNÀ] key.

Step 5:

Press the [VALUE+] key or [VALUE-] key to specify "Off", "Auto" or

"Manual".

Step 6:

Press the [ENTER] key to confirm "Media Cut" and shift to "Copy".

Step 7:

If no other items are to be changed, press the [BACK½] key.

Step 8:

Do not press any other keys for 3 minutes or press [BACK½] key again.

Step 9:

The permanent display is restored.

Plot OK

*Menu* Command>

*Menu* Function>

MediaCut: Off

MediaCut: Auto

MediaCut: Manual

Copy: 1