User`s guide

Rockhopper 38 – User’s Guide
Page 81 AP-75038, Rev. 1.0. – 27/05/04
5.4.2.7. Cut Position
This function specifies where the roll media will be cut in accordance with the specified layout of the print.
Data precedent:
Cuts the media at the position determined after adding a margin at the rear edge
of the page size specified by command or the printing area prescribed by max-
min in layout.
Standard size:
Cuts the media to the smallest standard size in the same series as the loaded
media that will accommodate the printing area determined by layout.