User`s guide

Rockhopper 38 – User’s Guide

Page 78 AP-75038, Rev. 1.0. – 27/05/04

5.4.2.5. Mirror

This function prints with printing data reversed in the Y-axis direction. Mirror may not work with some image

data.

Off:

No reversal

Y-axis on:

Reversing in the Y direction

To change the Mirror setup proceed as follows:

Step 1:

If a menu is to be specified, press the [MENU] key.

Step 2:

The key contents change to the purple section on the outside of the

operation panel.

Bring up the "Function" menu by pressing the [MENU UP¿] key or [MENU

DOWNÀ] key.

Step 3:

Press the [ENTER] key to confirm the "Function" menu and shift to the next

level.

Step 4:

Bring up the "Mirror" item by pressing the [MENU UP¿] key or [MENU

DOWNÀ] key.

Step 5:

Press the [VALUE+] or [VALUE-] key to set mirror to "Off" or "Y On".

Step 6:

Press the [ENTER] key to confirm "Mirror" for the applicable print and shift

to "Direction".

Step 7:

If no other items are to be changed, press the [BACK½] key.

Step 8:

Do not press any other keys for 3 minutes or press [BACK½] key again.

Step 9:

The permanent display is restored.

Plot OK

*Menu* Command>

*Menu* Function>

Mirror: Off

Mirror: Y-On

Direct: Command