User`s guide

Rockhopper 38 – User’s Guide
Page 74 AP-75038, Rev. 1.0. – 27/05/04
5.4.2. Function Setup
*Menu* Function >
Ink drying time 0 sec to 5 sec to 30 sec to 60 min
Halftone
Speed / Quality / Thin
CMY → Black
No / Yes
Scale
25% to 100% to 400%
Mirror
Off / Y-axis On
Direct.
Command / Max-Min
Cut pos.
Data / Standard
Media cut
Auto cut / Manual cut / Off
Copy
1 to 99
Eco-Solvent Plus ink
density
Normal / Faint / Thin
Distance adjustment
No / Clear / Change / Confirm
StepAdj.
Change / Clear
Factory default setting item is marked in Bold
5.4.2.1. Ink Drying Time
Ink drying times differ according to the type of media. After the printing is finished, roll media is cut off and
falls into the ejected media basket. If the ink is not yet dry, the media will be soiled. Ink drying time is the
delay to allow the ink to dry between the end of printing and the cutting of the roll media. The ink
drying time cycle is activated as soon as the printer has finalized the print.
Ink drying time: 0 sec, 5 sec, 10 sec, 20 sec, 30 sec, 40 sec, 50 sec, 60 sec, 90 sec, 120 sec, 150 sec,
180 sec, 210 sec, 240 sec, 270 sec, 300 sec.
To change the Ink Drying Time setup proceed as follows:
Step 1:
If a menu is to be specified, press the [MENU] key.
Step 2:
The key contents change to the purple section on the outside of the
operation panel.
Bring up the "Function" menu by pressing the [MENU UP¿] key or [MENU
DOWNÀ] key.
Step 3:
Press the [ENTER] key to confirm the "Function" menu and shift to the next
level.
Step 4:
Bring up the "Ink Dry Time" item by pressing the [MENU UP¿] key or
[MENU DOWNÀ] key.
Step 5:
Press the [VALUE+] key or [VALUE-] Key to select "0s", "5s", "10s", "20s",
"30s", "40s", "50s", "60s", "90s", "120s", "150s", "180s", "210s", "240s",
"270s" or "300s".
Step 6:
Press the [ENTER] Keys to confirm "Ink dry time" and shift to "Halftone".
Plot OK
*Menu* Command>
*Menu* Function>
InkDryTime: 30s
Halftone: Speed
InkDryTime: 30s
InkDryTime: 60s