User`s guide

Rockhopper 38 – User’s Guide

Page 72 AP-75038, Rev. 1.0. – 27/05/04

5.4.1.7. Overwrite

This specifies functions related to the printer's own environment. Specifies the method for controlling the

overwritten portions of a diagram.

Last:

Overwritten portion takes a colour to be printed later

Mix:

Overwritten portion takes mixed colours

To change the Overwrite setup proceed as follows:

Step 1:

If a menu is to be specified, press the [MENU] key.

The key contents change to the purple section on the outside of the

operation panel.

Step 2:

Press the [ENTER] key to confirm the "Command" menu and shift to the

next level.

Step 3:

Bring up the "Overwrite" item by pressing the [MENU UP¿] key or [MENU

DOWNÀ] key.

Step 4:

Press the [VALUE+] key or [VALUE-] key to select "Last" or "Mix".

Step 5:

Press the [ENTER] key to confirm "Command: Overwrite" and shift to the

next item to be set.

Step 6:

If no other items are to be changed, press the [BACK½] key.

Step 7:

Do not press any other keys for 3 minutes or press [BACK½] key again.

Step 8:

The permanent display is restored.

Plot OK

*Menu* Command>

Overwrite: Last

Overwrite: Mix

Command: OriginReste