User`s guide

Rockhopper 38 – User’s Guide
Page 71 AP-75038, Rev. 1.0. – 27/05/04
5.4.1.6. Online Timeout
When online data is broken off, this specifies a certain period of time, the elapsing of which is taken to be the
end of image data.
Online timeout: Off, 10 sec, 20 sec, 30 sec, 40 sec, 50 sec, 60 sec, 90 sec, 120 sec, 150 sec, 180 sec,
210 sec then in 30-sec increments to 720 sec, 750 sec, 780 sec, 800 sec.
To change the Online Timeout setup proceed as follows:
Step 1:
If a menu is to be specified, press the [MENU] key.
The key contents change to the purple section on the outside of the
operation panel.
Step 2:
Press the [ENTER] key to confirm the "Command" menu and shift to the
next level.
Step 3:
Bring up the "Online Timeout" item by pressing the [MENU UP¿] key or
[MENU DOWNÀ] key.
Step 4:
Press the [VALUE+] key or [VALUE-] key to select "Off", "10s", "10s",
"20s", "30s", "40s", "50s", "60s", "90s", "120s", "150s", "180s", "210s",
"240s", "270s" or "800s".
Step 5:
Press the [ENTER] key to confirm "Online timeout" and shift to "Command:
Overwrite".
Step 6:
If no other items are to be changed, press the [BACK½] key.
Step 7:
Do not press any other keys for 3 minutes or press [BACK½] key again.
Step 8:
The permanent display is restored.
Plot OK
Plot OK
*Menu* Command>
*Menu* Command>
Online Timer: 30 s
Online Timer: 720 s
Overwrite: Last