User`s guide

Rockhopper 38 – User’s Guide

Page 69 AP-75038, Rev. 1.0. – 27/05/04

5.4.1.4. Terminator

When the command item selected is MH-GL, GL2 (MH-RTL) or MH-GL/2 (MH-RTL), this specifies a function

that is different from the original command function as the terminator with respect to some commands in

each of the printer’s command modes.

Normal:

Only the original command is used

Special:

Recognizes the end of the data as the terminator SP0; (SP;)

To change the Terminator setup proceed as follows:

Step 1:

If a menu is to be specified, press the [MENU] key.

The key contents change to the purple section on the outside of the

operation panel.

Step 2:

Press the [ENTER] key to confirm the "Command" menu and shift to the

next level.

Step 3:

Bring up the "Terminator" item by pressing the [MENU UP¿] key or [MENU

DOWNÀ] key.

Step 4:

Press the [VALUE+] key or [VALUE-] key to select "Special" or "Normal".

Step 5:

Press the [ENTER] key to confirm "Command: Terminator" and shift to the

next item to be set.

Step 6:

If no other items are to be changed, press the [BACK½] Key.

Step 7:

Do not press any other keys for 3 minutes or press [BACK½] key again.

Step 8:

The permanent display is restored.

Plot OK

*Menu* Command>

Terminat: Special

Terminat: Normal

Resolut.: 360 dpi