User`s guide

Rockhopper 38 – User’s Guide
Page 68 AP-75038, Rev. 1.0. – 27/05/04
5.4.1.3. Position
When the command item selected is MH-GL, GL2 (MH-RTL) or MH-GL/2 (MH-RTL), this specifies the initial
pen position into the printer commands.
P1:
The initial position is P1 (scaling point)
LL:
The initial position is at the lower left of the hardclip.
Full:
The initial position is at the lower left of the media.
To change the Position (Origin) setup proceed as follows:
Step 1:
If a menu is to be specified, press the [MENU] key.
The key contents change to the purple section on the outside of the
operation panel.
Step 2:
Press the [ENTER] Key to confirm the "Command" menu and shift to the
next level.
Step 3:
Bring up the "Position" item by pressing the [MENU UP¿] key or [MENU
DOWNÀ] key.
Step 4:
Press the [VALUE+] key or [VALUE-] key to select "P1" , "LL(Headclip
lower left)" or "Full".
Step 5:
Press the [ENTER] key to confirm "Command: Position" and shift to the
next item to be set.
Step 6:
If no other items are to be changed, press the [BACK½] Key.
Step 7:
Do not press any other keys for 3 minutes or press [BACK½] key again.
Step 8:
The permanent display is restored.
Plot OK
*Menu* Command>
Position P1
Position LL
Plot OK
Position Full
Terminat: Special
*Menu* Command>