User`s guide

Rockhopper 38 – User’s Guide
Page 67 AP-75038, Rev. 1.0. – 27/05/04
Step 6:
Do not press any other keys for 3 minutes or press [BACK½] key again.
Step 7:
The permanent display is restored.
5.4.1.2.Print Area
Setting up the environmental functions of the printer. It specifies the printing area (hardclip area) for the
media size.
Normal:
Specifies the standard printing area for Rockhopper 38 printer
Distance from edges of media
Cut sheet : Front 25 mm, Back 20 mm, Sides 10 mm
Roll media : Front 25 mm, Back 20 mm, Sides 10 mm
Expanded:
Specifies a printing range that is interchangeable with Mutoh XP Series pen plotters.
However, since the maximum printing range is 934 mm, if expanded mode is
specified with media wider than 944 mm, the following left and right distances will be
wrong.
Distance from edges of media
Cut sheet : Front 25 mm, Back 20 mm, Sides 5 mm
Roll media : Front 25 mm, Back 20 mm, Sides 5 mm
To change the Print Area (Layout) setup proceed as follows:
Step 1:
If a menu is to be specified, press the [MENU] key.
The key contents change to the purple section on the outside of the
operation panel.
Step 2:
Press the [ENTER] key to confirm the "Command" menu and shift to the
next level.
Step 3:
Bring up the "Plot Area" item by pressing the [MENU UP¿] key or [MENU
DOWNÀ] key.
Step 4:
Press the [VALUE+] key or [VALUE-] key to select "Normal" or "Expand".
Step 5:
Press the [ENTER] key to confirm "Command: Plot Area" and shift to the
next item to be set.
Step 6:
If no other items are to be changed, press the [BACK½] key.
Step 7:
Do not press any other keys for 3 minutes or press [BACK½] key again.
Step 8:
The permanent display is restored.
Plot OK
Plot OK
*Menu* Command>
Plot Area: Normal
Plot Area: Expand
Position: P1
*Menu* Command>
Plot OK