User`s guide

Rockhopper 38 – User’s Guide
Page 66 AP-75038, Rev. 1.0. – 27/05/04
5.4. SETUP MENU.
5.4.1. Command Setup
*Menu* Command >
Command RTL-PASS / MH-GL, GL2 / MH-GL2
Print Area Normal / Expand
Initial Position P1 / (hardclip) LL / Full
Terminator Special / Normal
Resolution 300 dpi / 360 dpi / 720 dpi
Online Timeout Off / 10 sec to 30 sec to 800 sec
Overwrite Last / Mixed
OriginReset No / Yes
Factory default setting item is marked in Bold
5.4.1.1. Command
Setting up the transmittable commands and conditions from the computer.
The following commands are supported:
RTL-PASS
MH-GL, GL2 (MH-RTL): Mutoh MH-GL and MH-GL/2 (MH-RTL) commands (conform to
Hewlett-Packard HP-GL, HP-GL/2 and HP-RTL commands)
MH-GL2 (MH-RTL): Mutoh MH-GL/2 (MH-RTL) commands (conform to Hewlett-
Packard HP-GL/2 and HP-RTL commands) (MH-GL, GL2 plotting
unit is 0.025 mm)
To change the Command setup proceed as follows:
Plot OK
Step 1:
If a menu is to be specified, press the [MENU] key.
The key contents change to the purple section on the outside of the
operation panel.
Step 2:
Press [ENTER] key to confirm Command setup mode.
Step 3:
Specify “MH-GL, GL2”, “MH-GL2” or “RTL-PASS” by pressing the
[VALUE+] key or [VALUE-] key.
Step 4:
Press the [ENTER] key to confirm "Command: Command" and shift to the
next item to be set.
Step 5:
If no other items are to be changed, press the [BACK½] key.
Plot OK
*Menu* Command>
Command: Command>
Command: MH-GL, GL2
Command: MH-GL2
Command: RTL-PASS
Plot Area: Normal