User`s guide

Rockhopper 38 – User’s Guide
Page 63 AP-75038, Rev. 1.0. – 27/05/04
5.3.5. Roll media feed
When you use roll media, you can feed the media forward or
backward by pressing the shift key and the roll media advance key
up or down.
+
Note:
The media feed function does not work:
During data process / receive
When a cut-sheet is loaded
To perform roll media feed, proceed as follows:
Step 1:
It is only possible to use the media feed function when roll media has been loaded and when no data is being
processed.
Step 2:
Press the shift key + media feed key.
+
Step 3:
Release the keys to stop the media feed.
Note:
Damaged or dirty areas on the loaded media should be fed through using the Media
Feed function, prior to printing. Release the keys as soon as the dirty area is fed
beyond the printing head position. Afterwards, you can press the cancel key to sheet-off
the unusable part.