User`s guide

Rockhopper 38 – User’s Guide
Page 54 AP-75038, Rev. 1.0. – 27/05/04
5.2.4. Resolution
Pressing the Resolution key will change the output resolution between 720 x 720 dpi true
resolution and 360 x 360 dpi. The set-up can only be changed in idle status. As soon as
data is coming in and/or is being processed, pressing the key will not have any effect.
To change the resolution proceed as follows:
Make sure the printer is idle.
Press the Resolution key and select between 360 and 720 dpi
If 360 dpi is selected, the 360 dpi LED should be ON and if 720 dpi is selected, the 720 dpi LED should be
ON.
360 dpi
720 dpi
Important:
Always make sure that corresponding settings are being used on the software /
RIP side.