User`s guide

Rockhopper 38 – User’s Guide
Page 142 AP-75038, Rev. 1.0. – 27/05/04
7.4. MEMORY EXTENSION
All Rockhopper 38 printers come standard with a memory of 8 MB but this can be extended by fitting up to
two optional 16 MB (SIM16M) or 32 MB (SIM32M) memory boards (sold separately).
Caution:
When installing optional memory, make sure that the Rockhopper 38 printer is
switched off and the power cable is disconnected.
To install optional memory proceed as follows:
Remove roll paper and scroller from the printer. Undo the three screws holding the board box and carefully
lower the board box.
Board box fastening screws
Caution:
Electronic components are susceptible to damage by static electricity. Remove static
charge from your clothes and body by touching your hands to the board box before
you touch the additional memory chip.
Dust in the slot may cause damage. Blow it out with an air duster before installing
the additional memory.