User`s guide

Rockhopper 38 – User’s Guide
Page 140 AP-75038, Rev. 1.0. – 27/05/04
c. Centronics (Bi-directional parallel interface: IEEE1284) specifications:
Mode Compatible, Nibble, ECPmode
Port Port2
Data Length 8bits
Transmission Direction Uni-direction (receiving only), Bi-direction
Connector Pin N°.
Table of Parallel interface pin numbers and signals
Pin
No.
Connector Pin
number
Signal Direction Pin
No.
Connector Pin
number
Signal Direction
1 STROBE RJ Printer<- 19 SG
2 DATA1 RJ Printer<-> 20 SG
3 DATA2 RJ Printer<-> 21 SG
4 DATA3 RJ Printer<-> 22 SG
5 DATA4 RJ Printer<-> 23 SG
6 DATA5 RJ Printer<-> 24 SG
7 DATA6 RJ Printer<-> 25 SG
8 DATA7 RJ Printer<-> 26 SG
9 DATA8 RJ Printer<-> 27 SG
10 ACK RJ Printer-> 28 SG
11 BUSY RJ Printer-> 29 SG
12 P ERROR RJ Printer-> 30 SG
13 SELECTED RJ Printer-> 31 INIT RJ Printer<-
14 AUTOFD RJ Printer<- 32 FAULT RJ Printer->
15 Not Connected 33 Not connected
16 SG 34 Not connected
17 FG 35 Not connected
18 +5V 36 SELECTIN RJ Printer<-
d. Network Interface (Option) specifications:
Port Port3 (Only when it’s attached with an optional interface board)
Network Type Ethernet IEEE802.3
Network I/F 10BASE-T (RJ-45 Connector Twist Pair Cable)
10BASE-2 (BNC Connector Thin Same Axle Cable)
* Switchover
Protocol TCP/IP NetWare (V3.1J)
Mode * ftp * remote printer mode
* lpr * printer server
* socket
Spool memory 2.25 MB
Function Protocol Automatic recognition
Transmission Speed 50 -> 150 KB/S
IP address is set up at the remote panel utility
Any other command is installed with the telnet command