User`s guide

Rockhopper 38 – User’s Guide
Page 131 AP-75038, Rev. 1.0. – 27/05/04
6.11.4. Errors requiring a Restart
Errors requiring a restart are fatal to the operation of the printer. The power to the printer must be switched
off and the printer must be restarted. They are caused by an obstruction to the printer drive or damage
related to a printer board.
When an error requiring restart occurs, the printer behaves as follows.
1. Drive power is shut down automatically.
2. All LEDs on the operation panel flash and the beeper sounds continuously.
The beeper will not stop until a key is pressed.
3. An error code and error name are displayed in the liquid crystal display section.
Errors requiring restart that involve the Mechanical system
If an error has occurred in the mechanical system, remove the foreign object, paper scraps, etc. that are
causing the obstruction and restart the printer.
Feed motor error An error with the media feed motor has occurred.
Carriage motor error An error with the carriage motor has occurred.
Feed encoder error An error with the media feed encoder has occurred.
Carriage encoder error An error with the carriage encoder has occurred.
Feed imposition timeout An error with the media feed imposition has occurred.
Carriage imposition timeout An error with the carriage imposition has occurred.
Feed motor over current An error with the media feed motor has occurred.
Carriage motor over current An error with the carriage motor has occurred.
E065 Error X Motor
E066 Error Y Motor
E069 Error X Encoder
E070 Error Y Encoder
E071 Error X Timeout
E072 Error Y Timeout
E073 Error X Over current
E074 Error Y Over current