User`s guide

Rockhopper 38 – User’s Guide
Page 130 AP-75038, Rev. 1.0. – 27/05/04
6.11.3. Command Errors and Countermeasures
Command errors occur during the processing of command data received from the application or computer.
If the printer's command set-up differs from the type of command data sent from the application or computer
If there is a grammatical error in the command data sent from the application or computer
The beeper gives three long beeps when a data error occurs.
Note:
A command error may occur together with a data error (related to error code I15). In this
case, the communication settings should be checked.
The command that caused the error may be shown enclosed in brackets in the data
error message.
Undefined command error A command that is undefined by MH-GL command mode was
analyzed.
Parameter error An invalid number of parameters follow the command.
Numerical value error An invalid parameter follows the command.
Undefined character set A non-existent character set has been selected.
Position overflow
Buffer overflow The polygon buffer or downloadable buffer has overflowed.
Note:
In each case, first check that the command modes of the application and computer are
compatible with that of the printer. Refer to computer manual for application and
computer settings.
MH01 Error [ ]
MH02 Error [ ]
MH03 Error [ ]
MH04 Error [ ]
MH06 Error [ ]
MH07 Error [ ]