User`s guide

Rockhopper 38 – User’s Guide
Page 129 AP-75038, Rev. 1.0. – 27/05/04
6.11.2. Data Errors and Countermeasures
Data errors occur when there is a fault in communication between the printer and the application or
computer. There are three types of data error:
¾ Errors related to communication conditions
¾ Errors caused by faulty handshaking
¾ Escape sequence command format errors
The beeper gives three long beeps when a data error occurs.
Note:
The command that caused the error may be shown enclosed in brackets in the data
error message.
Network board detection error A board other than a prescribed network interface board has
been installed. Replace with a prescribed network interface
board.
Network board initialization error An error occurred when the network interface board was
installed. The network interface board may be faulty. Replace
the network interface board.
Detect Network Error
Initial Network Error