User`s guide

Rockhopper 38 – User’s Guide
Page 107 AP-75038, Rev. 1.0. – 27/05/04
30 min
After selecting this mode, the heaters will start heating towards the set temperature an remain at that
temperature for as long as 30 minutes. This time period is called “Preheat time”.
During this time the lower display line shows the remaining time: “Postheat: 29m59s”
As soon as the system starts printing the heaters will remain at that temperature as the printing continues:
“Heater Active”
When the printing stops, the heaters will continue to heat up to 30 minutes, after that time period, they will
switch off. This time period is called the ‘Postheat Time”.
During this time, the lower display line shows the remaining time: “Postheat: 29m59s”
Note:
¾ The displaying of the countdown time only begins at the moment the heaters
reaches their set temperature.
¾ During the period a heater is activated but has not yet reached the set temperature,
a thermometer icon will be shown that is building up.
¾ The moment a heater is activated and has reached the set temperature, a
thermometer icon will be shown that is flashing ON and OFF