User`s guide

Rockhopper 38 – User’s Guide
Page 103 AP-75038, Rev. 1.0. – 27/05/04
5.4.6.3. Data Dump
Prints a dump to check online.
Start-End:
Prints a dump from start to end
All:
Prints a dump for all data
To change the Data Dump setup proceed as follows:
Step 1:
If a menu is to be specified, press the [MENU] key.
Step 2:
The key contents change to the purple section on the outside of the
operation panel.
Bring up the "Utility" menu by pressing the [MENU UP¿] key or [MENU
DOWNÀ] key.
Step 3:
Press the [ENTER] key to confirm the "Utility" menu and shift to the next
level.
Step 4:
Bring up the "Data Dump" item by pressing the [MENU UP¿] key or
[MENU DOWNÀ] key.
Step 5:
Select "Start / End" or "All" by pressing the [MENU UP¿] key or [MENU
DOWNÀ] key.
Step 6:
Press the [ENTER] key to confirm Dump mode.
Step 7:
Send printing data from the application or host computer. Print with dump
mode.
Step 8:
If no other items are to be changed, press the [BACK½] key.
Step 9:
Do not press any other keys for 3 minutes or press [BACK½] key again.
Step 10:
The permanent display is restored.
Plot OK
Plot OK
*Menu* Command >
*Menu* Utility >
*Menu* Utility >
Dump: Start / End
Dump: All