User`s guide

Rockhopper 38 – User’s Guide
Page 101 AP-75038, Rev. 1.0. – 27/05/04
Step 6:
Press the [ENTER] key to confirm "Initial" and shift to "Initial All".
Step 7:
Bring up the "Initial Centro" item by pressing the [MENU UP¿] key or
[MENU DOWNÀ] key.
Step 8:
Press the [VALUE+] key or [VALUE-] key to specify "No" or "OK".
Step 9:
Press the [ENTER] key to confirm "Initial Centro" and shift to "Initial
Network".
Step 10:
If no other items are to be changed, press the [BACK½] key.
Step 11:
If no other items are to be changed, press the [BACK½] key.
Step 12:
Do not press any other keys for 3 minutes or press [BACK½] key again.
Step 13:
The permanent display is restored.
6. Network
Restores the backed up Network settings to the values set when shipped by Mutoh.
Yes:
The backed up Network settings are restored to the factory settings
No:
Factory settings are not restored
To change the Network setup proceed as follows:
Step 1:
If a menu is to be specified, press the [MENU] key.
Step 2:
The key contents change to the purple section on the outside of the
operation panel.
Bring up the "Utility" menu by pressing the [MENU UP¿] key or [MENU
DOWNÀ] key.
Step 3:
Press the [ENTER] key to confirm the "Utility" menu and shift to the next
level.
Plot OK
Plot OK
*Menu* Utility >
Initial: Yes >
Initial All: No
Initial Centro: No
Initial Centro: OK
InitialNetwork: No
Initial: No
*Menu* Utility >
*Menu* Command >