User`s guide

To improve printing quality
Question Answer Explanation Operation
Page 77 Page 77
Page 103 Page 124
To connect with Centronics
Question Answer Explanation Operation
Page 107 Page 136
Page 107 Page 137
To connect with network (Ethernet)
Question Answer Explanation Operation
Page 107 Page 138
To cut roll media
Question Answer Explanation Operation
Page 71 Page 71
When You Want to Do This
When You Want to Do This
If I want to give priority
to quality rather than
speed?
If I want to give priority
to graphic quality
rather than speed?
Light up the Quality LED
by pressing the [QUALITY
/ SPEED] key.
Set “Halftone” to
“Quality” diffusion for the
user number that you
want to change.
If I want to have bidi-
rectional communica-
tion with Centronics?
If I want to change
Centronics ACK/BUSY
timing control?
Change the Centronics
mode setting to
“Bi Centronics”.
Change “Timing” in
“Centronics” settings.
If I want to change the
IP address?
Change “IP address” in
“Network” settings.
If I want to feed and cut
the finished part of a
print?
Check that printing data
are not being received
then feed the media by
pressing the [MENU] key
while you are pressing
the [Shift] key and cut the
roll media by pressing
the [CANCEL] key.
Falcon Outdoor 46/62 USER GUIDE (AP-75046) 95