User`s guide

Loading the Media
Loading Roll Media
Preparing for Printing
Important:
·
The guide line (holes) is a guide.
There is a possibility of a jam if the pressure roller is not holding the
left edge of the media and the pressure roller is near the right edge.
Either hold the left edge of the media completely with the pressure
roller or slide it so that the pressure roller is about 5 mm away from
the right edge of the media and the right edge of the media within 5
mm to the left or right of the guide line (holes).
Step 13 :
·
Before lowering the media hold lever, hold the media on the front side and turn the
media feeding scroller slightly backward, making sure that there is an even tension
across the full media width.
·
Lower the media hold lever and close the cover.
·
The head moves automatically and will search for the left and right edge of the media
being loaded.
Important :
If the roll media has not been fed straight or incorrectly, messages such
as “Stuck Media error” or “Take out paper” are shown on the display. If
this is the case, reload the media following the instructions mentioned
above.
Step 1
4 :
In the MENU “Function” of your printer, set media cut to OFF.
Falcon Outdoor 46/62 USER GUIDE (AP-75046) 63