User`s guide

Loading the Media

Loading Roll Media

Step 2:

Stand behind the printer. Unlock the scroller

receiver by pressing the lock lever down.

You can now lift the right side of the scroller

and remove it from the printer.

Step 3:

Remove the roll media by gently pushing the roll media off the scroller via

the moveable flange side.

At no times drop the scroller end-caps on the floor as this might damage

the scroller end-caps and reduce media tracking or loading problems.

Preparing for Printing

Falcon Outdoor 46/62 USER GUIDE (AP-75046)

During the media detection sequence, check if the media runs straight. After media

detection, check the position of the right side of the roll media. If the position is almost on

the same line as it was before closing the cover, media loading was performed

successfully. If after the media detection sequence, the roll media position is not on the

same position as it was before closing the cover, repeat the instructions from steps 8 and

9 for installing the media.

Note:

Removing roll media

Step 1:

After printing, open the cover, tilt the media hold lever UP and wind up

the roll media.

Step 13: