User`s guide

Loading the Media

Loading Roll Media

Preparing for Printing

Falcon Outdoor 46/62 USER GUIDE (AP-75046)

Step 11: Fine-tuning the roll media position

If the gui

de line (holes) can be seen, the roll media must be moved to the right.

If the guide line (holes) is hidden, the roll media must be moved to the left.

· Turn the scroller receiver screw counter-

clockwise to move the roll media to the right

(when standing in front of the printer).

· Turn the scroller receiver screw clockwise to

move the roll media to the left (when standing

in front of the printer).

Step 10: Checking the position of roll media

Turn the scroller by hand and wind up several turns of roll media. As you wind up the

media, check the relative positions of the drive roller on the right and the right hand edge

of the roll media. It is normal if with the roll media pulled tight, the portion that is being

wound and the portion that was unwound are straight and the right hand side edge of the

media is on the guide line. If this is not the case, adjust the position of the roll media in

accordance with step 9.

Guide line (holes) can be seen Guide line (holes) is hidden