User`s guide

Loading the Media

Loading Roll Media

Preparing for Printing

Step 5: Load the media over the scroller

Turn the roll media as shown in the diagram and pass it over the scroller until the media

tube fits firmly over the fixed flange. Replace the movable flange on the scroller and fit it

firmly into the media tube.

Note:

· Do not drop the media roll over the scroller as this might damage the

scroller end caps.

· All Mutoh recommended roll media are rolled up with the printable

side facing the outside, so that you can load the roll media easily.

· When the cut sheet indicator light is ON when loading a roll, the

printer will display a media search error after feeding the media for

about 3m.

Step 7: Installing the scroller

Install the scroller as follows:

a) Stand at the back side of the printer, holding the scroller with the fixed flange side in

your left hand.

b) Slide the scroller (left side) into the scroller receiver, as shown in the illustration.

c) Push the scroller (Right side - movable flange side) down into the right scroller receiver.

You will notice it dropping nicely into place.

Falcon Outdoor 46/62 USER GUIDE (AP-75046)

Step 6: Installing the scroller slip ring

Install the scroller slip ring onto the scroller. Slide the scroller slip ring on the left side of

the scroller (side with fixed flange).