User`s guide

Step 5

Put the hold lever down.

• Remove the roll media and scroller from the main unit before

using.

• Don't load the media slantwise. The media size may be

misidentified and the printing will not be normal.

• If the roll media lamp is lit by the Control panel setting, a "Roll

media end" error may appear and printing will not terminate

normally or the media may be cut.

• Apart from the maximum size that may be loaded, cut media

can be loaded either longitudinally or laterally.

• Media has a printing surface and non-printing surface. Printing

on the non-printing surface may cause blurring or blemishes.

The printing surface is usually lighter.

Step 6

Close the cover. The head will move

automatically to detect the size of the

media.

Step 7

Removing the media

To remove the media, open the cover

and put the hold lever up, then remove

the media without touching the media

keeper blade.

Loading the Media

Loading Cut Media

NOTE

Con f i rmPape rKi nd

Plot OK

Falcon Outdoor 46/62 USER GUIDE (AP-75046)