User`s guide

Connecting the Power Cable

Preparing for Printing

1) Make sure the printer’s power switch is turned OFF.

2) Make sure the power of the Heating System and the Roll Take-Up System are turned

OFF.

3) Plug the printer-end of the power cable into the connector at the back of the printer.

4) Connect the cable of the Roll-Take-Up System with the Printer body.

5) Plug the other end of the power cable into an electrical outlet of the correct voltage and

with a proper grounding.

Power supply:

- Voltage: 200 to 240 VAC or 100 to 120 VAC

- Frequency: 50/60 Hz ± 1 Hz

- Current: < 10 A (110 V)

< 5 A (220 V)

Note:

· When you turn off the power, please note that your printer needs a

few seconds to perform its shut down sequence.

· To this end, wait for at least five seconds to switch the printer on

again.

The disconnect device is the plug on the power supply cord.

Falcon Outdoor 46/62 USER GUIDE (AP-75046)