User`s guide

Assembling the Printer

Now you can fix the sensor assy.

Fix the sensor assembly smoothly to the motor box, using 2 bolt + washers (use upper

holes) (detail A).

Hook the sensor bracket over the leg and secure it with a bolt + washer (detail B).

Step 3:

Loosen the wing screw which is fixed to the printing table (4) and remove the metal fixing

plate (5), which blocks the printer head during transportation. (See

on figure below).

Keep the metal fixing plate and wing screw, since the printing head needs to be

blocked during any transportation of your printer.

Caution:

· Take care not to drop the wing screw inside the printer body. Should

it fall in, do not boot up your printer until the wing screw has been

safely removed.

Preparing for Printing

Falcon Outdoor 46/62 USER GUIDE (AP-75046)