User`s guide

Assembling the Printer
Step 1:
Fix the pr
inter body onto the leg assembly using the two wing screws.
As mentioned in step 2 & 3 (Assembling the stand) the end plates
should be pulled as much as possible towards the upper part of the stand.
To do so, loosen a little bit the bolts temporarily fixing the endplates
with a hex key of 3 mm and make sure that they are pulled
as much as possible towards the stand. Now you can fix both
wing screws firmly. Once the wing screws are fastened, you can
secure the bolts on the endplates (see step 2 & 3) firmly with the hex key.
Step 2 :
The s
ensor assembly should be mounted on the right side of the stand.
Take the sensor bracket and put it through the outer slothole of the sensor assy.
34 Falcon Outdoor 46/62 USER GUIDE (AP-75046)