User`s guide

#It prints but the position is not right (there are places that
cannot be printed)
Possible Cause Remedy
Reference
Page
Page 48
Page 126
and 127
Page 122
Page 38
#Media jams occur frequently
• If the media is not media specified by Mutoh, proper media
feeding can not be guaranteed.
Possible Cause Remedy
Reference
Page
Page 48
Page 18
Page 48
Page 48
#Roll paper is not cut cleanly
Possible Cause Remedy
Reference
Page
Page 196
Page 71
When Trouble Strikes
(1) Is the media loaded in the
right position?
(2) Have you made scale or
mirror settings?
(3) Is an initial position speci-
fied?
(4) Is the printing abnormal
after ink was filled?
Load media correctly.
Cancel scale and mirror set-
tings or repeat the set-up.
Cancel initial position setting
or repeat the set-up
Leave for 24 hours after ink
filling and try printing again
(1) Are you using media spec-
ified by Mutoh?
(2) Is your usage environ-
ment other than that spec-
ified?
(3) Are you using old media?
(4) Is the media creased or
wrinkled?
Use media specified by Mutoh.
Use in the specified environ-
ment.
Replace with new media.
Replace with new media.
NOTE
(1) Is the cutter sharp?
(2) Is the media charged with
static electricity?
(3) Are you using cloth?
Replace cutter.
Remove static charge.
Cut cloth manually.
204 Falcon Outdoor 46/62 USER GUIDE (AP-75046)