User`s guide

Step 1
If a menu is to be specified, press the
[MENU] key.
Step 2
The key contents change to the purple
section on the outside of the control
panel.
Bring up the "Command" menu by
pressing the [Menu Up] key or [Menu
Down] key.
Step 3
Press the [ENTER] key to confirm the
"Command" menu and shift to the next
level
Step 4
Bring up the "OriginReset" item by press-
ing the [Menu Up] key or [Menu
Down] key.
Step 5
Press the [VALUE +] or [VALUE -] key
to select "Yes" or "No".
Step 6
Press the [VALUE +] or [VALUE -] key
to select "new origin" or "initialisation".
Step 7
Set a new origin (0 to media width minus 20
mm) and pressthe [ENTER] key to confirm.
Step 8
Do not press any other keys for 3 min-
utes or press [Back] key again.
Step 9
The permanent display is restored.
Command Settings: Origin Reset
Plot OK
*Menu* Command>
*Menu* Command>
OriginReset : No
Origin Reset: Yes
Origin : Init
Offset : 0
*Menu* Command>
Plot OK
Origin : New> To select a new origin select "new>" and
press
the [ENTER] key to confirm.
How to Set Parameters
Falcon Outdoor 46/62 USER GUIDE (AP-75046) 121