User`s guide

Rockhopper II series printers – User’s Guide
99
AP-75095, Rev. 2.1, 18/08/2005
5.4.44. Halftone menu
When creating prints of MH-GL/GL2 (vector) data and RTL-PASS (raster) data that has not been converted
into binary, to set the gradation sequence representation method.
* Halftone. *
F1 →
Speed Quality
← F2
F3 →
Thin
Current parameter →
- Speed - (1/1)
Setup items
Parameters Description
<Speed> To use the error diffusion matrix to perform rapid
gradation representation.
Quality Gradation representation is performed at high quality
according to the method of minimal average error.
Thin When printing data created for a competitor's printer,
make this setting if the "Speed" setting could result in
dark prints.
Halftone
- To shift to the previous hierarchy menu.
Refer to ‘Command setup menu’
5.4.45. Layout setup menu
Makes various settings on layout function.
Notes :
• The layout function automatically determines the size of printing data sent from the
computer, and then determines the amount of roll media required without wasting
media.
• If sheet media has been loaded, the layout function is disabled.
* Layout. *
F1 →
Direct. Joint
← F2
F3 →
CtPos.
(1/1)
Setup items
Parameters Description
Direct To set the layout method for printing data.
Refer to ‘Layout method menu’
Joint Makes settings for stitching print.
Refer to ‘Joint printing menu’
CtPos To set the media cutting position after printing has
been completed.
Refer to ‘Cutting position Menu’
Layout
- [CANCEL] key: To shift to the previous hierarchy
menu.
Refer to ‘Setup menu’