User`s guide

Rockhopper II series printers – User’s Guide
96
AP-75095, Rev. 2.1, 18/08/2005
5.4.37. Command select menu
To make the settings for the conditions of printer commands sent from the computer to the printer.
* Command *
F1 →
ML – GL. GL2 ML – GL2
← F2
F3 →
RTL – PASS
Current parameter →
- RTL –PASS - (1/1)
Setup items
Parameters Description
MH-GL, GL2 To set to MH-GL, GL2.
MH-GL2 To set to MH- GL2.
<RTL-PASS> To set to RTL-PASS.
Command
- To shift to the previous hierarchy menu.
Refer to ‘Command setup menu’
5.4.38. Print step menu
To set the units for amount of movement for printing.
* Step *
F1 →
0.010 mm 0.025 mm
← F2
Current parameter →
- 0.010 mm - (1/1)
Setup items
Parameters Description
<0.010mm> To set the printing units to 0.010mm.
<0.025mm> To set the printing units to 0.025mm.
Print step
- To shift to the previous hierarchy menu.
Refer to ‘Command setup menu’
Notes :
Please note that some software packages use the “
step per mm” terminology, in which
case a program step of 0.025 mm corresponds with 40 steps per mm and a program
step of 0.010 mm with 100 steps per mm.
5.4.39. Print position menu
To set the initial writing position for printing.
* Position *
F1 →
P1 LL
← F2
F3 →
Full
Current parameter →
- P1 - (1/1)
Setup items
Parameters Description
<P1> To set the initial location of the scaling point.
LL To set the lower left position of the hard clip.
Full To set the lower left position of the media.
Print position
- To shift to the previous hierarchy menu.
Refer to ‘setup menu’