User`s guide

Rockhopper II series printers – User’s Guide
90
AP-75095, Rev. 2.1, 18/08/2005
5.4.24. Media cut menu
Set media cut method after printing.
* MediaCut *
F1 →
Off Auto
← F2
F3 →
Manual
Current Parameter →
- Auto - (1/1)
Setup items
Parameters Description
Auto After printing has been completed, the media is sent
to the media cut position and is automatically cut.
Refer to ‘Cutting media’
Manual Feed media to the media cut position after printing.
Use regular cutting blades available from hardware
stores.
Refer to ‘Media cutting procedure’
Off No media feed after printing.
Media cutting
- When "ALL" is selected, proceed to the Shortest Cut
Length menu.
Refer to ‘Shortest cut menu’
• If "Manual" or "Off" has been selected, the screen
changes to the menu of the previous hierarchy.
Refer to ‘Media setup menu’
Notes :
• For the situations shown below, the media cut settings are always changed to "Off"
regardless the previous settings.
o When "Take-up system" or “Roll-up/roll off system” is set for the media
detection settings (Media detection menu)
• When using the media shown below, set the media cut setting to "Manual". If set to
"Auto", the following errors may occur :
o Cloth material: The cloth fiber is not completely cut.
o Media with glue: Glue will adhere to the cutting blade and decrease cutting
performance.
5.4.25. Shortest cut menu
To set the minimum page length for cutting media. (Only in the “Media Cutting → Auto”-menu available)
* ShortestCutPaper *
100 mm – 700 mm +
← F2
100 mm -
← F4
F2, F4
→ ENTER
Setup items
Parameters Description
Shortest Cut
Paper
<100mm>-700mm To set the shortest length of the media when cutting
• [F2] key : Increases the setting value.
• [F4] key : Reduces the setting value.
• [ENTER] key : Sets the setting value, and moves
the screen to the menu of the previous hierarchy.
• [CANCEL] key: Cancels the setup value, shift to the
previous hierarchy menu.
Refer to ‘Media setup menu’