User`s guide

Rockhopper II series printers – User’s Guide
89
AP-75095, Rev. 2.1, 18/08/2005
5.4.22. Cut size menu
When setting sheet media in the tray, set the method for detecting the size of the media.
* CutSize *
F1 →
Auto Length
← F2
F3 →
Width
Current parameter →
- Length - (1/1)
Setup items
Parameters Description
<Auto> The length and width of the sheet media is
automatically detected.
Length Make this setting when placing normal size sheet
media vertically on the tray.
Width Make this setting when placing normal size sheet
media horizontally on the tray.
Cut Size
- After setting, shift to the previous hierarchy menu.
Refer to ‘Media setup menu’
Notes :
• When using sheet media other than recommended media, set to "blank form
vertical" or "blank form horizontal".
• The following size of sheet media can be set.
o ISO series (A0, A1, A2, A3, A4)
o JIS series (B1, B2, B3, B4)
o ARCH series (A, B, C, D)
5.4.23. Top feed menu
Sets the amount of media to be fed when printing begins. Make this setting when using roll media.
* TopFeed *
0 mm – 400 mm +
← F2
0 mm -
← F4
F2, F4
→ ENTER
Setup items
Parameters Description
Top feed <0mm>-400mm To feed media at the start of printing. Set when
printing on roll media.
• "F2" key: Increases the setting value.
• "F4" key: Reduces the setting value.
• "ENTER" key: Sets the setting value, and moves
the screen to the menu of the previous hierarchy.
• [CANCEL] key: Cancels the setup value and shifts
to the previous hierarchy menu.
Refer to ‘Media setup menu’