User`s guide
Rockhopper II series printers – User’s Guide
83
AP-75095, Rev. 2.1, 18/08/2005
5.4.10. Head Height menu
Sets the distance (head height) between the print head and the media.
Head height can be changed to three levels according to media thickness.
* HeadHeight *
F1 →
Low Middle
← F2
F3 →
High
Current parameter →
- low - (1/1)
Setup items
Parameters Description
Low Make this setting when using media with a thickness
of 80µm (0.08mm) to 300µm (0.3mm).
Middle Make this setting when using media with a thickness
of 300µm (0.3mm) to 700µm (0.7mm).
High Make this setting when using media with a thickness
of 700µm (0.7mm) to 1000µm (1.0mm).
HeadHeight
- Refer to ‘User media menu’
Notes :
• Set the height of the head in relation to the thickness of the media.
o If the setting is set to "High" and the print is created on thin media, good
quality print results will not be achieved.
o If the setting is set to "Low" and thick media is used, the media and print
head will come into contact and may result in damage to the product.
5.4.11. Stiff menu
Sets the media sticking force (media stiffness) to the media guide.
* Stiff *
F1 →
Soft Normal
← F2
Current parameter →
- Normal - (1/1)
Setup items
Parameters Description
<Normal> Setting for normal media
Soft Setting for soft media where media feeding errors
and media jams occur
Stiff
- After setting, shift to the previous hierarchy menu.
Refer to ‘User media menu’