User`s guide

Rockhopper II series printers – User’s Guide
80
AP-75095, Rev. 2.1, 18/08/2005
5.4.7. User media menu
Makes various settings on user defined media.
In the User media menu, for each setup value of following printing operation, eight settings of "user media 1-
8" can be set.
Notes :
When media other than the recommended media are used (user media), the following
problems may occur :
¾ Media detection error
¾ Oblique, torn, and creased media
¾ Media jams
¾ Decrease in print quality due to blurring, missing, or smudging of ink
¾ End detection error of roll media
Problems caused by using media other than the recommended will void the warranty.
For more information, contact your local MUTOH dealer.
5.4.7.1. User media menu Rockhopper II
* User 1 *
F1 →
ThinOut InkDryTime
← F2
F3 →
HeadHeight Stiff
← F4
(1/3)
* User 1 *
F1 →
Thick Heater
← F2
F3 →
Drier HStatus
← F4
(2/3)
* User 1 *
F1 →
Dist. Adj
(3/3)
Setup items
Parameters Description
Amount of ink Sets the amount of ink discharged while printing according to the
media type. → Refer to ‘Ink amount menu’
InkDryTime In order to let the ink for the printing dry, the time between the end of
the print and the beginning of the next print is set. → Refer to ‘InkDry
menu’
HeadHeight Sets the distance (head height) between the print head and the
media. → Refer to ‘Head Height menu’
User media 1-8
(1/3)
Stiff Makes the setting for the absorbing power of the media to the printing
board depending on the hardness of the media. → Refer to ‘Stiff
menu’
Thickness
Makes the setting on the width of the media to be used. → Refer to
‘Thickness menu’
Heater
Sets the temperature of the Heater. → Refer to ‘Heater Menu’
Drier
Sets the temperature of the Drier. → Refer to ‘Drier Menu’
User media 1-8
(2/3)
HStatus
Checks the temperature of Heater and Drier. → Refer to ‘HStatus
Menu’
User media 1-8
(3/3)
Dist.Adj
Performs various settings for media feed compensation. → Refer to
‘Media feed compensation menu’