User`s guide

Rockhopper II series printers – User’s Guide
73
AP-75095, Rev. 2.1, 18/08/2005
5.4. MENU SETUP ON THE OPERATION PANEL
This section describes how to make the Menu settings on the operation panel, and setup items.
Follow the steps below to make the Menu settings.
Step 1 : Make sure that the operation panel is normal.
Ready to print
Heaters Cleaning
Cut&Feed Lever Up
User1 xxxm
Step 2 : Press the [MENU↑] or [MENU↓] key.
¾ The screen shows following Menu.
Current Setup Menu →
* SetupMenu *
F1 →
Ink Status OriginSet
← F2
F3 →
TestPrint MediaSet
← F4
(1/7)
Step 3 : Set the setup menu as follows :
¾ Refer to ‘Setup menu’ – ‘Tank change menu’
Notes :
• For functions of the operation panel with the setup menu displayed, refer to the
following :
o Operation panel
o Setting menu display
• For the structure of the setup menu, refer to the following :
o Setup menu structure
• When page numbers of the setup menu are displayed on the operation panel, you
can change the sequence by pressing the [MENU↑] or [MENU↓] key.
• Each table shows the factory default settings.